Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Topology overview
- 4 Preparation
- 5 S4148U-ON switch configuration
- 6 S4148U-ON validation
- 7 Configure Unity FC storage
- 8 Configure storage on ESXi hosts
- 9 Configure ESXi hosts for LAN traffic
- A Validated components
- B Technical support and resources
- C Support and feedback
52 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
R640-VDS created with uplinks port group
9.3 Add a distributed port group
In this section, a distributed port group is created on the distributed switch.
To create the port group:
1. On the Web Client Home screen, select Networking.
2. Right-click on the distributed switch, e.g., R640-VDS. Select Distributed Port Group > New
Distributed Port Group.
3. On the Select name and location page, provide a name for the distributed port group, e.g.,
Production. Click Next.
4. On the Configure settings page, next to VLAN type: select VLAN. Next to VLAN ID, specify the
VLAN configured earlier for LAN traffic on the leaf switches. In this deployment, VLAN 50 is used.
5. Leave the remaining values at their defaults and click Next > Finish.
When complete, the Navigator pane appears as shown:
Distributed port group created for production LAN traffic