Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Topology overview
- 4 Preparation
- 5 S4148U-ON switch configuration
- 6 S4148U-ON validation
- 7 Configure Unity FC storage
- 8 Configure storage on ESXi hosts
- 9 Configure ESXi hosts for LAN traffic
- A Validated components
- B Technical support and resources
- C Support and feedback
45 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
5. On the Snapshot page, leave settings at their defaults and click Next.
6. On the Replication page, leave settings at their defaults and click Next.
7. On the Summary page, review the details and click Finish to create the LUN.
8. On the Results page, click Close when Overall status shows 100% Completed.
The newly created LUN is now visible on the LUNs tab as shown in Figure 24. In this example, a LUN named
FC-80GB that is 80GB in size has been created.
LUN Created
Create additional LUNs and grant access (map) to hosts as needed.
Note: To modify host access at any time, check the box next to the LUN to select it. Click the icon, and
select the Host Access tab.