Deployment Guide

41 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
6.4.2 show lldp dcbx interface ethernet interface_number pfc detail
The show lldp dcbx interface ethernet interface_number pfc detail command is used to
verify PFC is enabled on dot1p priority 3 traffic, and its status is operational. It shows the FCoE TLV is
enabled and the FCoE priority map is set to 0x08, which maps to dot1p priority 3. (Hex 08 is binary 1000.
Counting bits from right to left and starting at 0, 1000 represents priority 3.)
S4148U-Leaf1# show lldp dcbx interface ethernet 1/1/31 pfc detail
Interface ethernet1/1/31
Admin mode is on
Admin is enabled, Priority list is 3
Remote is enabled, Priority list is 3
Remote Willing Status is enabled
Local is enabled, Priority list is 3
Oper status is init
PFC DCBX Oper status is Up
State Machine Type is Feature
PFC TLV Tx Status is enabled
Application Priority TLV Parameters :
--------------------------------------
FCOE TLV Tx Status is enabled
ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x08
14 Input TLV pkts, 14 Output TLV pkts, 0 Error pkts
14 Input Appln Priority TLV pkts, 6 Output Appln Priority TLV pkts, 0 Error
Appln Priority TLV Pkts
6.4.3 show lldp dcbx interface ethernet interface_number ets detail
The show lldp dcbx interface ethernet interface_number ets detail command is used to
verify configured ETS bandwidth settings are applied in the correct percentages to the correct priority
numbers, and ETS status is operational.
S4148U-Leaf1# show lldp dcbx interface ethernet 1/1/31 ets detail
Interface ethernet1/1/31
Max Supported PG is 8
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp Priority# Bandwidth TSA
------------------------------------------------
0 0,1,2,4,5,6,7 50% ETS
1 0% -