Deployment Guide

38 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
6.3 QoS commands
6.3.1 show qos maps
The show qos maps command shows the configured traffic-class-to-queue and dot1p-to-traffic-class maps.
The command output also displays default traffic-class maps (not used in this deployment and removed from
the output below to save space).
S4148U-Leaf1# show qos maps
Traffic-Class to Queue Map: map_GroupsToQueues
Queue Traffic-Class
--------------------------
0 0
3 3
DOT1P Priority to Traffic-Class Map : map_Dot1pToGroups
Traffic-Class DOT1P Priority
-------------------------------
0 0-2,4-7
3 3
(output truncated)
6.3.2 show policy-map
The show policy-map command shows the configured policy maps.
Note: The policy-iscsi application policy map is configured by default and is not used in this
deployment.
S4148U-Leaf1# show policy-map
Service-policy (application) input: policy-iscsi
Service-policy (qos) input: policy_Input_TrustDot1p
Class-map (qos): class-trust
trust dot1p
Service-policy (network-qos) input: policy_Input_PFC
Class-map (network-qos): class_Dot1p_3
pause
pfc-cos 3
Service-policy (queuing) output: policy_Output_BandwidthPercent
Class-map (queuing): map_ETSQueue_0
bandwidth percent 50
Class-map (queuing): map_ETSQueue_3
bandwidth percent 50