Deployment Guide

36 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
Switch Name 10:00:e4:f0:04:6b:04:42
Domain Id 100
Switch Port ethernet1/1/32
FC-Id 64:80:00
Port Name 20:01:18:66:da:77:d0:c3
Node Name 20:00:18:66:da:77:d0:c3
Class of Service 8
Symbolic Port Name QLogic 57800 bnx2fc v1.713.30.v60.6 over vmnic4
Symbolic Node Name QLogic 57800 bnx2fc v1.713.30.v60.6 over vmnic4
Port Type N_PORT
Registered with NameServer Yes
Registered for SCN Yes
6.2.3 show fc zoneset active
The show fc zoneset active command shows the zones and zone members in the active zone set.
Members logged into the fabric are shown with an asterisk (*).
S4148U-Leaf1# show fc zoneset active
vFabric id: 100
Active Zoneset: zoneset1
ZoneName ZoneMember
===========================================================
r640-1p1zone *20:01:18:66:da:71:50:ad
*50:06:01:66:47:e0:1b:19
*50:06:01:6e:47:e0:1b:19
r640-2p1zone *20:01:18:66:da:77:d0:c3
*50:06:01:66:47:e0:1b:19
*50:06:01:6e:47:e0:1b:19
6.2.4 show fcoe sessions
The show fcoe sessions command shows active FCoE sessions. The output includes MAC addresses,
Ethernet interfaces, the FCoE VLAN ID, FC IDs, and WWPNs of logged-in CNAs.
Note: Due to the width of the command output, each line of output is shown on two lines below.
S4148U-Leaf1# show fcoe sessions
Enode MAC Enode Interface FCF MAC FCF interface VLAN
FCoE MAC FC-ID PORT WWPN PORT WWNN
----------------------------------------------------------------------------
----------------------------------------------------------------------------