Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Topology overview
- 4 Preparation
- 5 S4148U-ON switch configuration
- 6 S4148U-ON validation
- 7 Configure Unity FC storage
- 8 Configure storage on ESXi hosts
- 9 Configure ESXi hosts for LAN traffic
- A Validated components
- B Technical support and resources
- C Support and feedback
28 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
The following commands are run to create the class maps:
S4148U-Leaf1
S4148U-Leaf2
class-map type network-qos
class_Dot1p_3
match qos-group 3
class-map type queuing map_ETSQueue_0
match queue 0
class-map type queuing map_ETSQueue_3
match queue 3
class-map type network-qos
class_Dot1p_3
match qos-group 3
class-map type queuing map_ETSQueue_0
match queue 0
class-map type queuing map_ETSQueue_3
match queue 3
QoS and policy maps are configured as follows:
S4148U-Leaf1
S4148U-Leaf2
trust dot1p-map map_Dot1pToGroups
qos-group 0 dot1p 0-2,4-7
qos-group 3 dot1p 3
qos-map traffic-class
map_GroupsToQueues
queue 0 qos-group 0
queue 3 qos-group 3
policy-map policy_Input_TrustDot1p
class class-trust
trust dot1p
policy-map type network-qos
policy_Input_PFC
class class_Dot1p_3
pause
pfc-cos 3
policy-map type queuing
policy_Output_BandwidthPercent
class map_ETSQueue_0
bandwidth percent 50
class map_ETSQueue_3
bandwidth percent 50
trust dot1p-map map_Dot1pToGroups
qos-group 0 dot1p 0-2,4-7
qos-group 3 dot1p 3
qos-map traffic-class
map_GroupsToQueues
queue 0 qos-group 0
queue 3 qos-group 3
policy-map policy_Input_TrustDot1p
class class-trust
trust dot1p
policy-map type network-qos
policy_Input_PFC
class class_Dot1p_3
pause
pfc-cos 3
policy-map type queuing
policy_Output_BandwidthPercent
class map_ETSQueue_0
bandwidth percent 50
class map_ETSQueue_3
bandwidth percent 50