Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Topology overview
- 4 Preparation
- 5 S4148U-ON switch configuration
- 6 S4148U-ON validation
- 7 Configure Unity FC storage
- 8 Configure storage on ESXi hosts
- 9 Configure ESXi hosts for LAN traffic
- A Validated components
- B Technical support and resources
- C Support and feedback
16 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
4.3 Determine CNA FCoE port WWPNs
The PowerEdge R640 server's FCoE adapter World Wide Port Names (WWPNs) are used for FC zone
configuration. Adapter WWPNs are determined as follows:
1. Connect to the first server's iDRAC in a web browser and log in.
2. Select System > Network Devices.
3. Click on the CNA. In this example, it is Integrated NIC 1. Under Ports and Partitioned Ports, the
FCoE partition for each port is displayed as shown in Figure 12:
FCoE partitions in iDRAC
4. The first FCoE partition is Port 1, Partition 2. Click the icon to view the MAC Addresses as shown
in Figure 13.