Reference Guide

View policy-map
OS10(conf-if-eth1/1/1)# do show policy-map
Service-policy (qos) input: p1
Class-map (qos): c1
set qos-group 1
Service-policy (queuing) output: p2
Class-map (qos): c2
set qos-group 2
OS10(conf-if-eth1/1/1)# do show policy-map
Service-policy(qos) input: pmap1
Class-map(qos): class-trust
trust dot1p
View QoS interface conguration
OS10(conf-if-eth1/1/1)# do show qos interface ethernet 1/1/1
Interface ethernet 1/1/1
unknown-unicast-storm-control : Disabled
multicast-storm-control : Disabled
broadcast-storm-control : Disabled
flow-control-rx : Disabled
flow-control-tx : Disabled
Service-policy (Input)(qos): p1
Service-policy (Output)(queuing): p2
OS10(conf-if-eth1/1/1)# do show qos interface ethernet 1/1/1
Interface
unknown-unicast-storm-control : Disabled
multicast-storm-control : Disabled
broadcast-storm-control : Disabled
flow-control-rx : Disabled
flow-control-tx : Disabled
ets mode : Disabled
Control-plane policy-map
You can apply the policies created to the control-plane.
1 Enter CONTROL-PLANE conguration mode from CONFIGURATION mode.
control-plane
2 Apply the service policy, and create a name for the policy-map in CONTROL-PLANE mode.
service-policy input policy-map-name
Attach policy-map to control-plane
OS10(config)# control-plane
OS10(conf-control-plane)# service-policy input p1
View control-plane service policy
OS10(conf-control-plane)# do show qos control-plane
Service-policy (Input)(control-plane): p1
System policy-map
The policies applied in the SYSTEM-QOS mode are applicable to all of the interfaces in the system.
NOTE
: If both the interface-level and system-level policy-map are available at the same time, the interface-level policy-map gets
priority.
548 Quality of service