Reference Guide

1.1.1.1 1615 0x80000125 5 ethernet1/1/1
2.2.2.2 1369 0x8000011B 5 ethernet1/1/1
10.0.0.2 1044 0x80000001 5 ethernet1/1/1
Type-5 AS External Link States
ADV Router Age Seq# Prefix
--------------------------------------------------------------------------
3.3.3.3 3116 0x80000126 400::/64
3.3.3.3 3116 0x80000124 34::/64
Supported Releases 10.3.0E or later
show ipv6 ospf interface
Displays the congured OSPFv3 interfaces. You must enable OSPFv3 to display the output.
Syntax
show ipv6 ospf interface interface
Parameters interface — (Optional) Enter the interface information:
• ethernet — Physical interface (1 to 48)
• port-channel — Port-channel interface (1 to 128).
• vlan — VLAN interface 1 to 4094).
Default Not congured
Command Mode EXEC
Example
OS10# show ipv6 ospf interface
ethernet1/1/1 is up, line protocol is up
Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
Network Type broadcast, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
Designated Router on this network is 2.2.2.2
Backup Designated router on this network is 10.0.0.2 (local)
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported Releases 10.3.0E or later
show ipv6 ospf neighbor
Displays a list of OSPFv3 neighbors connected to the local router.
Syntax
show ipv6 ospf neighbor
Parameters None
Default Not congured
Command Mode EXEC
Usage Information
• Neighbor ID—Displays the neighbor router ID.
• Pri—Displays the priority assigned neighbor.
• State—Displays the OSPF state of the neighbor.
• Dead Time—Displays the expected time until the system declares the neighbor dead.
• Interface—Displays the interface type, node/slot/port or number information.
390 Layer 3