Reference Guide

-- Unit 1 --
Status : up
System Identifier : 1
Down Reason : user-triggered
System Location LED : off
Required Type : S6000
Current Type : S6000
Hardware Revision : A01
Software Version : 10.2.9999E
Bios Version : None
Physical Ports : 32x40GbE
BIOS : 3.33.0.2
System CPLD : 0.3
Master CPLD : 0.4
Slave CPLD : 0.2
-- Power Supplies --
PSU-ID Status Type AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up DC REVERSE 1 7200 up
2 up DC REVERSE 1 7200 up
-- Fan Status --
FanTray Status AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up REVERSE 1 7000 up
2 7000 up
2 up REVERSE 1 7000 up
2 7000 up
3 up REVERSE 1 7000 up
2 7000 up
Candidate conguration
When you enter OS10 conguration commands in the transaction-based conguration mode, changes do not take eect immediately and
are stored in the candidate conguration. The conguration changes become active on the network device only after you commit the
changes with the commit command. Changes in the candidate conguration are validated and applied to the running conguration.
The candidate conguration allows you to avoid introducing errors during an OS10 conguration session. You can make changes and then
check them before committing them to the active, running conguration on the network device.
Use the show diff command to check dierences between the running conguration and the candidate conguration. After comparing
the two, you can decide if you would like to commit the changes to the running conguration. Use the
discard command to delete
uncommitted changes.
• Enter show ? from EXEC mode to view a list of commands to monitor a device.
OS10# show ?
aaa Current candidate aaa configuration
access-list Current candidate access-list configuration
as-path Current candidate as-path configuration
bgp Current candidate bgp configuration
class-map Current candidate class-map configuration
community-list Current candidate community-list configuration
compressed Current candidate configuration in compressed format
control-plane Current candidate control-plane configuration
dot1x Current candidate dot1x configuration
extcommunity-list Current candidate extcommunity-list configuration
interface Current candidate interface configuration
lacp Current candidate lacp configuration
lldp Current candidate lldp configuration
Getting Started
33