Reference Guide

Command Mode INTERFACE
Usage Information When you congure an EdgePort on a device running STP, the port immediately transitions to Forwarding state.
Only congured ports connected to end hosts act as EdgePorts.
Example
OS10(config)# spanning-tree port type edge
Supported Releases 10.2.0E or later
show spanning-tree mst
Displays MST conguration information.
Syntax
show spanning-tree mst configuration
Parameters None
Default Not congured
Command Mode EXEC
Usage Information Enable MSTl prior to using this command.
Example
OS10# show spanning-tree mst configuration
Region Name: asia
Revision: 0
MSTI VID
0 1,7-4093
1 2
2 3
3 4
4 5
5 6
Supported Releases 10.2.0E or later
show spanning-tree msti
Displays MST instance information.
Syntax
show spanning-tree msti [instance-number [brief | guard | interface interface]]
Parameters
• instance-number — (Optional) Displays MST instance information (0 to 63).
• brief — (Optional) Displays MST instance summary information.
• guard — (Optional) Displays which guard is enabled and current port state.
• interface interface — (Optional) Displays interface type information:
• ethernet node/slot/port[:subport] — Enter the Ethernet port information (1 to 48).
• port-channel — Enter the port-channel interface information (1 to 128).
Default Not congured
Command Mode EXEC
Usage Information View the MST instance information for a specic MST instance number in detail or brief, or view physical
(Ethernet) port or port-channel information.
Example (Brief)
OS10# show spanning-tree msti 0 brief
Spanning tree enabled protocol msti with force-version mst
Layer 2 207