Reference Guide

Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command deactivates the zoneset. After you disable an active zoneset, the zone
default-zone permit command conguration takes eect. Based on this conguration, the default zone
allows or denies access between all the logged-in FC nodes of the vfabric.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported Releases 10.3.1E or later
FCoE commands
clear fcoe database
Clears the FCoE database for the specied VLAN.
Syntax
clear fcoe database vlan vlan-id {enode enode-mac-address | fcf fcf-mac-address
| session fcoe-mac-address}
Parameters
• vlan-id — Enter the VLAN ID.
• enode-mac-address — Enter the MAC address of ENode.
• fcf-mac-address — Enter the MAC address of FCF.
• fcoe-mac-address — Enter the MAC address of FCoE session.
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# clear fcoe database vlan 100 enode aa:bb:cc:00:00:00
Supported Releases 10.4.0E(R1) or later
clear fcoe statistics
Clears FCoE statistics for specied interface.
Syntax
clear fcoe statistics [interface interface-type]
Parameters
interface-type — (Optional) Enter the interface type. The interface may be
ethernet, VLAN, or port-channel.
Default Not congured
Command Mode EXEC
Usage Information If you do not specify the interface interface-type information, then the command clears the statistics
for all the interfaces and VLANs.
134 Fibre channel