Deployment Guide

14 Dell EMC Networking FCoE Deployment with S4148U-ON in NPG Mode
5.2 Configure switches
After setting the switch port profile on both S4148U-ONs, the commands in the tables that follow are run to
complete the FC configuration on both switches.
Note: The commands in the tables below should be entered in the order shown. Switch running-configuration
files are provided as attachments named S4148U-Leaf1.txt and S4148U-Leaf2.txt.
Configure global switch settings
Configure the hostname, OOB management IP address, and OOB management default gateway. Configure
the first port group in FC mode for 16GFC.
These FC interfaces are used to connect to the Brocade 6510 FC switches.
S4148U-Leaf1
S4148U-Leaf2
configure terminal
hostname S4148U-Leaf1
interface mgmt 1/1/1
no ip address dhcp
ip address 100.67.166.219/24
no shutdown
management route 0.0.0.0/0
100.67.166.254
port-group 1/1/1
mode fc 16g-2x
configure terminal
hostname S4148U-Leaf2
interface mgmt 1/1/1
no ip address dhcp
ip address 100.67.166.220/24
no shutdown
management route 0.0.0.0/0
100.67.166.254
port-group 1/1/1
mode fc 16g-2x
Note: For more information on mapping ports to switch profiles and port groups, see
OS10 Enterprise Edition
User Guide Release 10.4.2.0, Unified port groups, page 84.
Configure VLT between the two S4148U-ON switches
VLT synchronizes Layer 2 and ARP table information between the switches and enables a single port channel
to be connected to the switch pair as if they are a single switch.
S4148U-Leaf1
S4148U-Leaf2
interface range ethernet 1/1/29-1/1/30
no switchport
vlt-domain 127
backup destination 100.67.166.220
discovery-interface ethernet 1/1/29
discovery-interface ethernet 1/1/30
peer-routing
interface range ethernet 1/1/29-1/1/30
no switchport
vlt-domain 127
backup destination 100.67.166.219
discovery-interface ethernet 1/1/29
discovery-interface ethernet 1/1/30
peer-routing