Deployment Guide

24 Dell EMC Networking Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
fibrechannel1/1/3
fibrechannel1/1/5
fibrechannel1/1/7
==========================================
Note: By default, the Default Zone Mode is set to Deny. This setting denies access between FC nodes
except those in the same zone of the active zone set. To allow access between FC nodes in the absence of
an active zone set, change the Default Zone Mode to Allow with the following command sequence:
S4148U-Leaf1# configure terminal
S4148U-Leaf1(config)# vfabric vfabric_number
S4148U-Leaf1(conf-vfabric-100)# zone default-zone permit