Deployment Guide

23 Dell EMC Networking Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
6.4 show fc zoneset active
The show fc zoneset active command shows the zones and zone members in the active zone set.
Members logged into the fabric are shown with an asterisk (*).
S4148U-Leaf1# show fc zoneset active
vFabric id: 100
Active Zoneset: zoneset1
ZoneName ZoneMember
===========================================================
r640-1p1zone *20:01:00:0e:1e:09:a2:3a
*50:06:01:66:47:e0:1b:19
*50:06:01:6e:47:e0:1b:19
r640-2p1zone *20:01:00:0e:1e:09:b8:f6
*50:06:01:66:47:e0:1b:19
*50:06:01:6e:47:e0:1b:19
6.5 show vfabric
The show vfabric command output provides a variety of information including the default zone mode, the
active zone set, and interfaces that are members of the vfabric.
S4148U-Leaf1# show vfabric
Fabric Name
Fabric Type FPORT
Fabric Id 100
Vlan Id 1002
FC-MAP 0xEFC64
Vlan priority 3
FCF Priority 128
FKA-Adv-Period Enabled,8
Config-State ACTIVE
Oper-State UP
==========================================
Switch Config Parameters
==========================================
Domain ID 100
==========================================
Switch Zoning Parameters
==========================================
Default Zone Mode: Deny
Active ZoneSet: zoneset1
==========================================
Members
fibrechannel1/1/1