Deployment Guide

19 Dell EMC Networking Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
Server and storage adapter WWPNs, or their aliases, are combined into zones to allow communication
between devices in the same zone. Dell EMC recommends single-initiator zoning. In other words, no more
than one server HBA port per zone. For high availability, each server HBA port should be zoned to at least
one port from SP A and one port from SP B.
In this deployment, one zone is created for each server HBA port. The zone contains the server port and the
two storage processor ports connected to the same S4148U-ON.
S4148U-Leaf1
S4148U-Leaf2
fc zone r640-1p1zone
member alias-name r640-1p1
member alias-name SpB-0
member alias-name SpA-0
fc zone r640-2p1zone
member alias-name r640-2p1
member alias-name SpB-0
member alias-name SpA-0
fc zone r640-1p2zone
member alias-name r640-1p2
member alias-name SpB-1
member alias-name SpA-1
fc zone r640-2p2zone
member alias-name r640-2p2
member alias-name SpB-1
member alias-name SpA-1
A zone set is a collection of zones. A zone set named zoneset1 is created on each switch, and the zones are
added to it.
Note: Multiple zone sets may be configured on a switch, but only one zone set can be active at any time.
S4148U-Leaf1
S4148U-Leaf2
fc zoneset zoneset1
member r640-1p1zone
member r640-2p1zone
exit
fc zoneset zoneset1
member r640-1p2zone
member r640-2p2zone
exit
Create the FCoE VLAN, vfabric, FCoE map, and activate the zone set. In this deployment, the FCoE VLAN is
set to 1002, the vfabric ID is set to 100 (valid range is 1-255), and the fcmap is set to 0xEFC64 (valid range is
0xEFC00-0xEFCFF).
Note: The FCoE VLAN and FCoE map are used internally by the switch to forward FC traffic, even if FCoE
is not used by nodes connected to the switch.
S4148U-Leaf1
S4148U-Leaf2
interface vlan 1002
vfabric 100
vlan 1002
fcoe fcmap 0xEFC64
zoneset activate zoneset1
interface vlan 1002
vfabric 100
vlan 1002
fcoe fcmap 0xEFC64
zoneset activate zoneset1