Reference Guide

Supported Releases 10.4.0E(R1) or later
p-snooping enable
Enables FIP snooping on specied VLAN.
Syntax
fip-snooping enable
Parameters None
Defaults Disabled
Command Mode VLAN INTERFACE
Usage Information
The no version of this command disables FIP snooping on the VLAN.
You can enable FIP snooping on a VLAN only after enabling the FIP snooping feature globally using the feature
fip-snooping
command. OS10 supports FIP snooping on a maximum of 12 VLANs.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping enable
Supported Releases 10.4.0E(R1) or later
p-snooping fc-map
Congure the FC map value for specic VLAN.
Syntax
fip-snooping fc-map fc-map
Parameters fc-map — Enter the FC map ID, ranging from 0xefc00 to 0xefc.
Defaults Not congured
Command Mode VLAN INTERFACE
Usage Information
The no version of this command disables the FC map conguration.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
Supported Releases 10.4.0E(R1) or later
p-snooping port-mode fcf
Sets the FIP snooping port mode to FCF for interfaces.
Syntax
fip-snooping port-mode fcf
Parameters None
Defaults ENode port mode
Command Mode INTERFACE
130 Fibre channel