Reference Guide

Defaults Not congured
Command Mode INTERFACE
Usage Information
The no version of this command removes the vfabric from the FC interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
Supported Releases 10.3.1E or later
vlan
Associate an existing VLAN ID to the vfabric to carry trac. Create the VLAN ID before associating it to the vfabric. Do not use spanned
VLAN as vfabric VLAN.
Syntax
vlan vlan-ID
Parameters vlan-ID — Enter an existing VLAN ID.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command removes the VLAN ID from the vfabric.
Example
OS10(config)# interface vlan 1023
10OS10(conf-if-vl-1023)# exit
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# vlan 1023
Supported Releases 10.3.1E or later
zone default-zone permit
Enables access between all logged-in FC nodes of vfabric in the absence of an active zoneset conguration. A default zone advertises a
maximum of 527 members in the registered state change notication (RSCN) message.
Syntax
zone default-zone permit
Parameters None
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command disables access between FC nodes in the absence of an active zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported Releases 10.3.1E or later
142 Fibre channel