Reference Guide

Parameters
• node/slot — Enter 1/1 for node/slot when you congure a port group.
• port-group — Enter the port-group number (1 to 10).
Default Not congured
Command mode CONFIGURATION
Usage information Enter PORT-GROUP mode to congure unied ports in Fibre Channel or Ethernet mode. To view the ports that
belong to a port group, enter the show port-group command.
Example
OS10(config)# port-group 1/1/8
OS10(conf-pg-1/1/8)#
Supported releases 10.3.1E or later
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
• phy-eth node/slot/port[:subport] — Display information about physical ports connected to the
interface.
• status — Display interface status.
• ethernet node/slot/port[:subport] — Display Ethernet interface information.
• loopback id — Display loopback IDs (0 to 16383).
• mgmt node/slot/port — Display Management interface information.
• null — Display null interface information.
• port-channel id-number — Display port channel interface IDs (1 to 128).
• vlan vlan-id — Display the VLAN interface number (1 to 4094).
Default Not congured
Command Mode EXEC
Usage Information Use the do show interface command to view interface information from other command modes.
Example
OS10# show interface
Ethernet 1/1/2 is up, line protocol is up
Hardware is Dell EMC Eth, address is 00:0c:29:54:c8:57
Current address is 00:0c:29:54:c8:57
Pluggable media present, QSFP-PLUS type is QSFP_40GBASE_CR4_1M
Wavelength is 64
Receive power reading is 0.0
Interface index is 17305094
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Enabled
Link local IPv6 address: fe80::20c:29ff:fe54:c857/64
Global IPv6 address: 2::1/64
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 40G, Auto-Negotiation on
FEC is auto, Current FEC is off
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 00:40:14
Interfaces 93