Reference Guide

Example
OS10(config)# link-bundle-utilization trigger-threshold 10
Supported Releases 10.2.0E or later
mgmt
Congures the specied VLAN as the management VLAN.
Syntax
mgmt
Parameters None
Default Not congured
Command Mode VLAN INTERFACE
Usage Information Use the no version of this command to remove the conguration.
Example
OS10(config)# interface vlan 11
OS10(conf-if-vl-11)# mgmt
Supported Releases 10.3.0E or later
mode
Congures a front-panel unied port group to operate in Fibre Channel or Ethernet mode with the specied speed on activated interfaces.
Syntax
mode {Eth {100g-1x | 50g-2x | 40g-1x | 25g-4x | 10g-4x} | FC {32g-2x | 32g-1x |
16g-2x |8g-4x}}
Parameters
• mode Eth — Congure a unied port group in Ethernet mode and set the speed to:
• 10g-4x — Split a QSFP28 or QSFP+ port into four 10G interfaces.
• 25g-4x — Split a QSFP28 port into four 25G interfaces.
• 40g-1x — Set a QSFP28 port to 40G mode to use with a QSFP+ 40GE transceiver.
• 50g-2x — Split a QSFP28 port into two 50G interfaces.
• 100g-1x — Reset a QSFP28 port to 100G mode.
• mode FC — Congure a unied port group in Fibre Channel mode and set the speed to:
• 8g-4x — Split a QSFP28 or SFP+ port group into four 8GFC interfaces.
• 16g-2x — Split a QSFP28 or SFP+ port group into two 16GFC interfaces using ports 1 and 3.
• 16g-4x — Split a QSFP28 port group into four 16GFC interfaces.
• 32g-1x — Split a QSFP28 port group into one 32GFC interface, subport 1.
• 32g-2x — Split a QSFP28 port group into two 32GFC interfaces, subports 1 and 3.
Default Depends on the port prole activated.
Command Mode PORT-GROUP
Usage Information
• The mode {FC | Eth} command congures a unied port to operate at line rate and guarantees no trac
loss.
• The no version of the command resets port-group interfaces to the default Ethernet port mode/speed. Use
the
no mode command before you reset the mode on an interface.
Interfaces 91