Reference Guide

• View the conguration of OSPF neighbors connected to the local router in EXEC mode.
show ipv6 ospf neighbor
• View routes that OSPF calculates in EXEC mode.
show ipv6 ospf routes
View OSPF Conguration
OS10# show running-configuration ospfv3
!
interface ethernet1/1/1
ip ospf 100 area 0.0.0.0
!
router ospf 100
log-adjacency-changes
OSPFv3 Commands
area stub
Denes an area as the OSPF stub area.
Syntax
area area-id stub [no-summary]
Parameters
• area-id—Set the OSPFv3 area ID as an IP address (A.B.C.D) or number (1 to 65535).
• no-summary—(Optional) Prevents an area border router from sending summary link advertisements into the
stub area.
Default Not congured
Command Mode ROUTER-OSPFv3
Usage Information The no version of this command deletes a stub area.
Example
OS10(config)# router ospfv3 10
OS10(conf-router-ospfv3-10)# area 10.10.1.5 stub
Supported Releases 10.3.0E or later
auto-cost reference-bandwidth
Calculates default metrics for the interface based on the congured auto-cost reference bandwidth value.
Syntax
auto-cost reference-bandwidth value
Parameters value — Enter the reference bandwidth value to calculate the OSPFv3 interface cost in megabits per second (1
to 4294967).
Default 100000
Command Mode ROUTER-OSPFv3
Usage Information The value set by the ipv6 ospf cost command in INTERFACE mode overrides the cost resulting from the
auto-cost command. The no version of this command resets the value to the default.
Example
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# auto-cost reference-bandwidth 150
Supported Releases 10.3.0E or later
Layer 3 327