Reference Guide

Default 100000
Command Mode ROUTER-OSPF
Usage Information The value set by the ipv6 ospf cost command in INTERFACE mode overrides the cost resulting from the
auto-cost command. The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# auto-cost reference-bandwidth 150
Supported Releases 10.2.0E or later
clear ip ospf process
Clears all OSPF routing tables.
Syntax
clear ip ospf {instance-number} process
Parameters instance-number — Enter an OSPF instance number (1 to 65535).
Default Not congured
Command Mode EXEC
Usage Information This command clears all entries in the OSPF routing table.
Example
OS10# clear ip ospf 3 process
Supported Releases 10.2.0E or later
default-information originate
Generates and distributes a default external route information to the OSPF routing domain.
Syntax
default-information originate [always]
Parameters always — (Optional) Always advertise the default route.
Defaults Disabled
Command Mode ROUTER-OSPF
Usage Information The no version of this command disables the distribution of default route.
Example
OS10(config)# router ospf 10
OS10(config-router-ospf-10)# default-information originate always
Supported Releases 10.3.0E or later
default-metric
Assigns a metric value to redistributed routes for the OSPF process.
Syntax
default-metric number
Parameters number — Enter a default-metric value (1 to 16777214).
Default Not congured
Command Mode ROUTER-OSPF
Usage Information The no version of this command disables the default-metric conguration.
302 Layer 3