Reference Guide

Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage Information This command enables LLDP globally for all Ethernet (PHY) interfaces, except on those interfaces where LLDP is
manually disabled. The no version of this command disables LLDP globally irrespective of whether LLDP is
manually enabled on an interface.
Example
OS10(config)# lldp enable
Supported Releases 10.3.1E or later
lldp holdtime-multiplier
Congures the multiplier value for the hold time (in seconds).
Syntax
lldp holdtime-multiplier integer
Parameters integer — Enter the holdtime-multiplier value in seconds (2 to 10).
Default 4 seconds
Command Mode CONFIGURATION
Usage Information Hold time is the amount of time (in seconds) that a receiving system waits to hold the information before
discarding it. Formula: Hold Time = (Updated Frequency Interval) X (Hold Time Multiplier). The no version of this
command resets the value to the default.
Example
OS10(config)# lldp holdtime-multiplier 2
Supported Releases 10.2.0E or later
lldp med fast-start-repeat-count
Congures the number of packets sent during the activation of the fast start mechanism.
Syntax
lldp-med fast-start-repeat-count number
Parameters number — Enter the number of packets sent during the activation of the fast start mechanism (1 to 10).
Default 3
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# lldp med fast-start-repeat-count 5
Supported Releases 10.2.0E or later
lldp med
Enables or disables LLDP-MED on an interface.
Syntax
lldp med {enable | disable}
Layer 2 153