Reference Guide

Supported Releases 10.4.0E(R1) or later
p-snooping fc-map
Congure the FC map value for specic VLAN.
Syntax
fip-snooping fc-map fc-map
Parameters fc-map — Enter the FC map ID, ranging from 0xefc00 to 0xefc.
Defaults Not congured
Command Mode VLAN INTERFACE
Usage Information
The no version of this command disables the FC map conguration.
Example
OS10(config)# interface vlan 3
OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
Supported Releases 10.4.0E(R1) or later
p-snooping port-mode fcf
Sets the FIP snooping port mode to FCF for interfaces.
Syntax
fip-snooping port-mode fcf
Parameters None
Defaults ENode port mode
Command Mode INTERFACE
Usage Information
By default, the port mode of an interface is set to ENode. Use this command to change the port mode to FCF. You
can set the port mode to FCF only after enabling the FIP snooping feature.
The no version of this command resets the port mode to ENode.
Example
OS10(config)# interface ethernet 1/1/32
OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf
Supported Releases 10.4.0E(R1) or later
FCoE commands
The following commands are supported on all the three modes: F_Port, NPG, and FSB.
clear fcoe database
Clears the FCoE database for the specied VLAN.
Syntax
clear fcoe database vlan vlan-id {enode enode-mac-address | fcf fcf-mac-address
| session fcoe-mac-address}
146 Fibre Channel