Reference Guide

Parameters zoneset-name — Enter an existing zoneset name.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command deactivates the zoneset. After you disable an active zoneset, the zone
default-zone permit command conguration takes eect. Based on this conguration, the default zone
allows or denies access between all the logged-in FC nodes of the vfabric.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported Releases 10.3.1E or later
NPG commands
The following commands are supported on NPG mode:
fc port-mode F
Congures port mode on Fibre Channel interfaces.
Syntax
fc port-mode F
Parameters None
Defaults N_Port
Command Mode Fibre Channel INTERFACE
Usage Information Congure the port mode when the port is in shut mode and when NPG mode is enabled. The no version of this
command returns the port mode to default.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# fc port-mode F
Supported Releases 10.4.1.0 or later
feature fc npg
Enables the NPG mode globally.
Syntax
feature fc npg
Parameters None
Defaults Disabled
Command Mode CONFIGURATION
Usage Information
The no version of this command disables the NPG mode. You can enable only any one of the following at a time:
F_Port, FIP snooping bridge, or NPG.
Example
OS10(config)# feature fc npg
138 Fibre Channel