Users Guide

port-group
Configures a group of front-panel unified ports, or a double-density QSFP28 (QSFP28-DD) or single-density QSFP28 port
group.
Syntax
port-group node/slot/port-group
Parameters
● node/slot — Enter 1/1 for node/slot when you configure a port group.
● port-group — Enter the port-group number, from 1 to 16. The available port-group range depends
on the switch.
Default Not configured
Command mode CONFIGURATION
Usage
information
Enter PORT-GROUP mode to:
● Configure unified ports in Fibre Channel or Ethernet mode and break out interfaces with a specified
speed.
● Break out a Z9264F-ON QSFP28 port group into multiple interfaces with a specified speed.
To view the ports that belong to a port group, use the show port-group command.
Example
OS10(config)# port-group 1/1/8
OS10(conf-pg-1/1/8)#
Supported
releases
10.3.1E or later
profile
Configures breakout interfaces on a Z9264F-ON switch.
Syntax
profile {restricted | unrestricted}
Parameters
● restricted — Applies only to the odd-numbered port within the port group. The even-numbered
port in the port group is disabled. Supported speeds are:
○ 100g-1x
○ 40g-1x
○ 25g-4x
○ 10g-4x
● unrestricted — Applies to both the odd-numbered and even-numbered ports within the port
group. Supported speeds are:
○ 100g-1x
○ 50g-2x
○ 40g-1x
Default Unrestricted
Command mode PORT-GROUP
Usage
information
Enter the profile command to configure breakout interfaces. Use the port command to specify the
speed. The Z9264F-ON switch has a total of 64 physical ports and can support a maximum of 128 logical
ports. To view the ports that belong to a port group, use the show port-group command.
Example
OS10(config)# port-group 1/1/2
OS10(conf-pg-1/1/2)# profile restricted
Supported
releases
10.4.3.0 or later
Interfaces 407