Reference Guide

Parameters None
Default Not congured
Command Mode EXEC
Usage Information The lock command fails if there are uncommitted changes in the candidate conguration.
Example
OS10# lock
Supported Releases 10.2.0E or later
management route
Congures an IPv4/IPv6 static route used by the Management port. Repeat the command to congure multiple management routes.
Syntax
management route {ipv4-address/mask | ipv6-address/prefix-length} {forwarding-
router-address | managementethernet}
Parameters
• ipv4-address/mask — Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet
mask in prex-length format (/xx).
• ipv6-address/prefix-length — Enter an IPv6 address in x:x:x:x::x format with the prex length
in /xxx format (prex range is /0 to /128).
•
forwarding-router-address — Enter the next-hop IPv4/IPv6 address of a forwarding router
(gateway) for network trac from the management port.
• managementethernet — Congure the Management port as the interface for the route; forces the route
to be associated with the management interface.
Default Not congured
Command Mode CONFIGURATION
Usage Information Management routes are separate from IP routes and are only used to manage the system through the
management port. To display the currently congured IPv4 and IPv6 management routes, enter the show ip
management-route and show ipv6 management-route commands.
Example (IPv4)
OS10(config)# management route 10.10.20.0/24 10.1.1.1
OS10(config)# management route 172.16.0.0/16 managementethernet
Example (IPv6)
OS10(config)# management route 10::/64 10::1
Supported Releases 10.2.2E or later
move
Moves or renames a le on the cong or home system directories.
Syntax
move [config: | home: | usb:]
Parameters
• config: — Move from conguration directory (config://filepath).
• home: — Move from home directory (home://filepath).
• usb: — Move from USB le system (usb://filepath).
Getting Started 63