Reference Guide

The following shows the output of the show commands on Router 2.
Router 2
OS10# show ip vrf
VRF-Name Interfaces
blue Eth1/1/5
Vlan128
default Mgmt1/1/1
Vlan1,24-25,200
green Eth1/1/7
Vlan256
orange Eth1/1/6
Vlan192
OS10# show ip route vrf blue
Codes: C - connected
S - static
B - BGP, IN - internal BGP, EX - external BGP
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, * - candidate default,
+ - summary route, > - non-active route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
------------------------------------------------------------------------------------------------
C 21.0.0.0/24 via 21.0.0.1 ethernet1/1/5 0/0 02:05:00
OS10# show ip route vrf orange
Codes: C - connected
S - static
B - BGP, IN - internal BGP, EX - external BGP
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, * - candidate default,
+ - summary route, > - non-active route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
------------------------------------------------------------------------------------------------
C 31.0.0.0/24 via 31.0.0.1 ethernet1/1/6 0/0 02:09:19
OS10# show ip route vrf green
Codes: C - connected
S - static
B - BGP, IN - internal BGP, EX - external BGP
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, * - candidate default,
+ - summary route, > - non-active route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
------------------------------------------------------------------------------------------------
C 41.0.0.0/24 via 41.0.0.1 ethernet1/1/7 0/0 02:45:16
======================================================================================
View VRF instance information
To display information about VRF conguration, enter the show ip vrf command. To display information on all VRF instances (including
the default VRF 0), do not enter a value for
vrf-name.
• Display the interfaces assigned to a VRF instance.
276
Layer 3