Reference Guide

Vlan 320 is up, line protocol is up
Address is , Current address is
Interface index is 69209184
Internet address is not set
MTU 1532 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 240
Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface
status change:
Access mode
An access port is an untagged member of only one VLAN. Congure a port in Access mode and congure which VLAN carries the trac
for that interface. If you do not congure the VLAN for a port in Access mode (or an access port), the interface carries trac for VLAN 1
(default VLAN).
Change the access port membership in a VLAN by specifying the new VLAN. You must create the VLAN before you can assign the port in
Access mode to that VLAN. Use the no switchport access vlan command to reset to default VLAN.
1 Congure a port in INTERFACE mode.
interface ethernet node/slot/port[:subport]
2 Set the interface to Switchport mode as access in INTERFACE mode.
switchport mode access
3 Enter the VLAN number for the untagged port in INTERFACE mode.
switchport access vlan vlan-id
Congure port in access mode
OS10(config)# interface ethernet 1/1/9
OS10(config-if-eth1/1/9)# switchport mode access
OS10(config-if-eth1/1/9)# switchport access vlan 604
Show running conguration
OS10# show running-configuration
...
!
interface ethernet1/1/5
...
switchport access vlan 604
no shutdown
!
interface vlan1
no shutdown
...
Trunk mode
A trunk port can be a member of multiple VLANs set up on an interface. A trunk port can transmit trac for all VLANs. To transmit trac
on a trunk port with multiple VLANs, OS10 uses tagging or the 802.1q encapsulation method.
1 Congure a port in INTERFACE mode.
interface ethernet node/slot/port[:subport]
2 Change the Switchport mode to Trunk mode in INTERFACE mode.
switchport mode trunk
Layer 2
251