Users Guide

Usage
Information
● The configurations are supported only in the multiswitch mode.
● This command specifies the maximum interval. You must first receive a hello message on the selected
interface before the neighbor is considered lost and removed from the database.
● The no form of this command resets the command to default value, 80 s.
Example
OS10(config-if-fc-1/1/1)#fspf dead-interval 90
Supported
Releases
10.5.1.0 or later
fspf hello-interval
Configures the FSPF hello interval value for every interface.
Syntax
fspf hello-interval timeout-val
Parameters
timeout-val—Valid values are from 1 to 65535.
Defaults 20 s
Command Mode Fiber Channel INTERFACE
Usage
Information
● The configurations are supported only in multiswitch mode.
● This command specifies the hello message interval to verify the health of the link in the VSAN.
● The no version of this command resets to the default value.
Example
OS10(config-if-fc-1/1/1)#fspf hello-interval 30
Supported
Releases
10.5.1.0 or later
fspf hold-time
Configures the FSPF hold-time value for vfabric.
Syntax
fspf hold-time timeout-val
Parameters
timeout-val—Valid values are from 0 to 65535.
Defaults 0ms
Command Mode VFABRIC CONFIGURATION
Usage
Information
● The configurations are supported only in multiswitch mode.
● This command configures the hold-time between two consecutive route computations in milliseconds,
for the entire vfabric. If the specified time is shorter, the routing update is faster. However, the
processor consumption increases accordingly.
NOTE: Configure the same hold timer value on all the switches for consistent route convergence,
and to avoid intermittent traffic loop.
● The no version of this command resets to the default value of 0ms.
Example
OS10(conf-vfabric-<vfabric-id>)#fspf hold-time 5000
Supported
Releases
10.5.1.0 or later
452 Fibre Channel