Reference Guide

port-group
Congures a group of front-panel unied ports or a double-density QSFP28 (QSFP28-DD) port.
Syntax
port-group node/slot/port-group
Parameters
• node/slot — Enter 1/1 for node/slot when you congure a port group.
• port-group — Enter the port-group number (1–14). The available port-group range depends on the switch.
Default Not congured
Command mode CONFIGURATION
Usage information Enter PORT-GROUP mode to:
• Congure unied ports in Fibre Channel or Ethernet mode and break out interfaces with a specied speed.
• Break out a QSFP28-DD port into multiple interfaces with a specied speed.
To view the ports that belong to a port group, enter the show port-group command.
Example
OS10(config)# port-group 1/1/8
OS10(conf-pg-1/1/8)#
Supported releases 10.3.1E or later
show discovered-expanders
NOTE
: This command will be supported in future releases.
Syntax
show discovered-expanders
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
• phy-eth node/slot/port[:subport] — Display information about physical ports connected to the
interface.
• status — Display interface status.
• ethernet node/slot/port[:subport] — Display Ethernet interface information.
• loopback id — Display loopback IDs (0 to 16383).
• mgmt node/slot/port — Display Management interface information.
• null — Display null interface information.
• port-channel id-number — Display port channel interface IDs (1 to 128).
• vlan vlan-id — Display the VLAN interface number (1 to 4093).
Default Not congured
Interfaces 107