Setup Guide
You must supply:
• One two-hole UL-certied GND lug to attach the ground wire to the rack
• Two National Electric Code (NEC)-compliant screws to attach the GND lug to the rack
• Anti-oxidant compound
• Crimping tool
1 Measure and cut a length of wire sucient to reach between the system-installed GND
lug and the rack-end GND lug.
2 Attach the end of the wire to the rack-end GND lug.
a Coat the bare end of the wire with an anti-oxidant compound.
b Insert the end of the wire into the lug.
c Crimp the lug end to secure the connection.
Figure 10. Ground wire and GND lug
3 Install the second GND lug in compliance with NEC guidelines on your rack.
Use this assembly to ground the switch.
a Ensure that the rack mating surface is clean.
b Bring any bare metal to a bright nish.
c Apply the anti-oxidant compound to the mating surfaces before mating.
Hardware installation
19