Setup Guide

3 Repeat this procedure for the second rail.

Figure 6. Two-post center-mount conguration

Four-post threaded conguration

NOTE

: To be NEBS Earthquake Z4-compliant, you must remove the tool-less latch

castings described in Step 1.

1 Remove the latch castings from each end of the ReadyRails assemblies.

To remove the two screws from each ange ear and remove the latch castings, use a

Torx driver, item 1. Retain the castings for future rack requirements.

2 Attach the front and rear anges of each railing to the post anges with two user-

supplied screws at each end, item 2.

Hardware installation