Install Guide

Align and seat the back ange rail pegs in the back vertical post ange. This illustration shows how the pegs appear in both the square

and unthreaded round holes.

2 Align and seat the front ange pegs in the holes on the front side of the vertical post.

3 Repeat this procedure for the second rail.

4 To remove each rail, pull on the latch release button on each ange ear and unseat each rail.

Figure 10. 1U tool-less conguration

Two-post ush-mount conguration

CAUTION

: Your system is not NEBS Earthquake Z4-compliant if you use this installation method.

1 Remove the tool-less latch castings from the front side of each ReadyRails assembly, item 1.

Use a Torx driver to remove the two screws from each front ange ear on the switch side of the rail. Remove each latch casting.

Retain the castings for future rack requirements. It is not necessary to remove the rear ange castings.

2 Attach one rail to the front post ange with two user-supplied screws, item 2.

3 Slide the plunger bracket forward against the vertical post and secure the plunger bracket to the post ange with two user-supplied

screws, item 3.

4 Repeat this procedure for the second rail.

S4048T-ON installation