Concept Guide

Field Description
Remote Parameters ETS conguration on remote peer port, including Admin mode
(enabled if a valid TLV was received or disabled), priority groups,
assigned dot1p priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for DCBx exchange, the
Willing bit received in ETS TLVs from the remote peer is included.
Local Parameters ETS conguration on local port, including Admin mode (enabled
when a valid TLV is received from a peer), priority groups, assigned
dot1p priorities, and bandwidth allocation.
Operational status (local port) Port state for current operational ETS conguration:
• Init: Local ETS conguration parameters were exchanged with
peer.
• Recommend: Remote ETS conguration parameters were
received from peer.
• Internally propagated: ETS conguration parameters were
received from conguration source.
ETS DCBx Oper status Operational status of ETS conguration on local port: match or
mismatch.
State Machine Type Type of state machine used for DCBx exchanges of ETS
parameters:
• Feature: for legacy DCBx versions
• Asymmetric: for an IEEE version
Conf TLV Tx Status Status of ETS Conguration TLV advertisements: enabled or
disabled.
ETS TLV Statistic: Input Conf TLV pkts Number of ETS Conguration TLVs received.
ETS TLV Statistic: Output Conf TLV pkts Number of ETS Conguration TLVs transmitted.
ETS TLV Statistic: Error Conf TLV pkts Number of ETS Error Conguration TLVs received.
The following example shows the show stack-unit all stack-ports all pfc details command.
DellEMC(conf)# show stack-unit all stack-ports all pfc details
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 2 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
The following example shows the show stack-unit all stack-ports all ets details command.
DellEMC(conf)# show stack-unit all stack-ports all ets details
Stack unit 0 stack port all
Max Supported TC Groups is 4
Number of Traffic Classes is 1
Admin mode is on
Admin Parameters:
300
Data Center Bridging (DCB)