Administrator Guide

IPv6 route using a next-hop IPv6 address in order for the ping command to detect the
destination address.
interface ip-
address
Enter the keyword interface then the IP address.
distance (OPTIONAL) Enter the value of the distance metric assigned to the route. The range is
from 1 to 255.
name description (OPTIONAL) Enter the keyword name and the description for the IPv4 static route
configuration.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route must not be
removed even if the interface assigned to that route goes down. The route must be
currently active to be installed in the routing table. If you disable the interface, the route is
removed from the routing table.
tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to the route. The range is
from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF. Use this VRF option after the
next hop to specify which VRF the next hop belongs to. This setting is used in route
leaking cases. See “R”oute Leaking VRFs” in the Virtual Routing and Forwarding (VRF)
section of the Configuration guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination
address and not for the route pointing to destination a interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.2) Added the keyword name for static routes.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Included the weighted parameter to support weighted ECMP feature.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
IPv4 Routing 781