Administrator Guide

port-delay-restore (Configuration Mode)
Allows a delayed bring up of all interfaces during switch boot up.
Syntax
port-delay-restore value
To return to the default value, use the no port-delay-restore command.
Parameters
value Enter a timer value from 1 second to 300 seconds.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command-Line Reference Guide.
Version Description
9.14(2.3) Introduced on the C9000, S3048-ON, S3100 series, S4048-ON, S4048T-ON, S5048F-
ON, S6000, S6000-ON, S6010-ON, S6100-ON, and Z9100-ON.
Usage Information
When you enable this feature, it allows you to set the delay timer value between 1 second to 300 seconds on all
ports globally.
To disable the timer on all ports, use the no port-delay-restore command.
To disable the timer on an individual interface, use the no port-delay-restore command in the INTERFACE
mode.
NOTE: In a stacking environment, the port-delay-restore timer kicks in for each individual stack-
unit separately as it boots up.
Related
Commands
no port-delay-restore (Interface Mode) — disables delayed bring up of individual interfaces during switch
boot up.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this way is identified as a hybrid port in
report displays.
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode hybrid
command.
Defaults non-hybrid
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
692 Interfaces