Administrator Guide

Version Description
9.3(0.1) Added the http parameter on the S6000, Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
8.4.1.0 Added IPv6 addressing support for FTP, TFTP, and SCP.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added usbflash and rpm0usbflash commands on E-Series.
7.6.1.0 Introduced on the S-Series and added the SSH port number to the SCP prompt sequence
on all systems.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
Dell EMC Networking OS supports a maximum of 100 files at the root directory level on both the internal and
external flash.
When copying a file to a remote location (for example, using Secure Copy [SCP]), enter only the keywords and
Dell EMC Networking OS prompts you for the rest of the information. For example, when using SCP, you can
enter
copy running-config scp: where running-config is the source and the target is specified in the
ensuing prompts. Dell EMC Networking OS prompts you to enter any required information for the named
destination — remote destination, destination filename, user ID, password, and so forth.
When you use the copy running-config startup-config command to copy the running configuration
to the startup configuration file, Dell EMC Networking OS creates a backup file on the internal flash of the startup
configuration.
When you load the startup configuration or a configuration file from a network server such as TFTP to the running
configuration, the configuration is added to the running configuration. This does not replace the existing running
configuration. Commands in the configuration file has precedence over commands in the running configuration.
Dell EMC Networking OS supports copying the running-configuration to a TFTP server, an FTP server, or a
remote NFS file system. For example:
• copy running-config tftp:
• copy running-config ftp:
• copy running-config nfsmount://<mount-point>/filepath
You can compress the running configuration by grouping all the VLANs and the physical interfaces with the same
property. You can store the operating configuration to the startup config in Compressed mode and perform an
image downgrade without any configuration loss.
Example
DellEMC#copy running-config scp:
Address or name of remote host []: 192.168.1.1
Port number of the server [22]: 22
Destination file name [startup-config]:
User name to login remote host: username
Password to login remote host:
!
4080 bytes successfully copied
DellEMC#
In this copy scp: flash: example, specifying SCP in the first position indicates that you need to specify the
target in the ensuing prompts. Entering flash: in the second position indicates that the target is the internal
flash. The source is on a secure server running secure shell (SSH), so you are prompted for the user datagram
protocol (UDP) port of the SSH server on the remote host.
Example
DellEMC# copy running-config nfsmount://<mount-point>/filepath
Destination file name [test.txt]:
User name to login remote host: usrname
File Management 61