Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048T-ON

261

262

263

264

265

266

267

268

269

270

When there are multiple routes to the same destination, the routes with a higher weight

are preferred.

Defaults router-originated = 32768; all other routes = 0

Defaults Not configured.

Command Modes ROUTE-MAP

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

Usage Information If you do not use the set weight command, router-originated paths have a weight attribute of 32768 and all

other paths have a weight attribute of zero.

show config

Display the current route map configuration.

Syntax