Administrator Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information This command displays the contents of the flash:/ADMIN_DIR/ssh/authorized-keys.username file.
Example
DellEMC# show ip ssh rsa-authentication my-authorized-keys
ssh-rsa
AAAAB3NzaC1yc2EAAAABIwAAAIEAyB17l4gFp4r2DRHIvMc1VZ
d0Sg5GQxRV1y1X1JOMeO6Nd0WuYyzrQMM
4qJAoBwtneOXfLBcHF3V2hcMIqaZN+CRCnw/
zCMlnCf0+qVTd1oofsea5r09kS0xTp0CNfHXZ3NuGCq9Ov33m9+
U9tMwhS8vy8AVxdH4x4km3c3t5Jvc=
freedom@poclab4
DellEMC#
Related
Commands
• ip ssh rsa-authentication (Config) — configures the RSA authorized keys.
ssh
Open an SSH connection specifying the hostname, username, encryption cipher, HMAC algorithm, port number, and version of the SSH
client.
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell EMC Networking representative.
ssh [vrf vrf-name] {hostname | ipv4 address | ipv6 address} [-c encryption
cipher | -l username | -m HMAC algorithm | -p port-number | -v 2]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to specify the VRF
used with the SSH session.
NOTE: The VRF configured using this command has a higher precedence
than the VRF configured using the ip ssh vrf vrf-name command. If you
do not configure a VRF using this command, then the SSH client uses the
configured VRF (if any). If there is a mismatch between VRFs that are
1416 Security