Administrator Guide

Power Supply 1 Output Voltage(VOUT) : 12.210000 V
Power Supply 1 Input Current(IIN) : 0.380000 A
Power Supply 1 Output Current(IOUT) : 5.390000 A
Power Supply 1 Input Power(PIN) : 75.000000 W
Power Supply 1 Output Power(POUT) : 65.700000 W
Power Supply 1 Temperature : 30.000000 C
Power Supply 1 Fan Present
Power Supply 1 Fan Status is Normal
Power Supply 1 Fan Airflow Type is F2B
Power Supply 1 Fan Speed(RPM) : 9088
Getting details of Power Supply 2 using LPC interface
Power Supply 2 is Present
Power Supply 2 Input Type AC
Power Supply 2 Input Voltage(VIN) : 203.000000 V
Power Supply 2 Output Voltage(VOUT) : 12.190000 V
Power Supply 2 Input Current(IIN) : 0.440000 A
Power Supply 2 Output Current(IOUT) : 6.400000 A
Power Supply 2 Input Power(PIN) : 87.000000 W
Power Supply 2 Output Power(POUT) : 77.200000 W
Power Supply 2 Temperature : 30.000000 C
Power Supply 2 Fan Present
Configuration File format
The configuration file for the psutool has a single supply on each line:
Power Supply 2 | cpld | lpc | 0 | 0x0204 | 0x1 | 4 | 0 | 0x0204 | 6 | 1 | x | i2c | 3 | 0x5b |
0x53 | i2c /dev/i2c-3 0x73:0:0:0x40:,:0x71:0:0:8:,:0x72:0:0:0 |
i2c | 0 | 0x40 | 0x4 | - | 0 | 0 | 0
• PSU Name — The name of the supply to display. The entries do not have to be in any named order.
• Tool Name — Name of the tool.
• Access to Present and Power Good — The type of access to the CPLD, i2c, LPC, and MEM.
• Access bus — For i2c devices. Shows which i2c bus to use.
• Address — For LPC devices, the address of the device or register.
• Register — Access size for LPC.
• Present Bit(s) — The bit or bits to indicate presence. The range of bits display as end:start and must be contiguous.
Disaggregate sets of bits are not supported.
• PresentValue — The value present.
• Power Good Register, Bit(s) and Value — The bit or bits to indicate present. The range of bits display as end:start
and must be contiguous. Disaggregate sets of bits are not supported.
• Tool Acess Mux Definitions — If your system needs a MUX to access the CPLD, the MUX definitions display here.
• FRU and FAN Register access — Supports i2c, LPC, and MEM.
smartctl
smartctl controls the self-monitoring, analysis, and reporting technology (SMART) system built into most ATA/SATA and
SCSI/SAS hard drives and solid-state drives. The purpose of SMART is to monitor the reliability of the hard drive and predict
drive failures, and to carry out different types of drive self-tests.
smarttool
This is an optional tool and is only available on systems using a SmartFusion chip.
Use the smarttool to get and set the Smartfusion Active regions and version, and to reprogram the Smartfusion FPGA.
Dell DiagOS Tools 70