Administrator Guide

Part No: EL-13-08002-001
Revision: 01
Serial Num: 28-0197
ID : 0x11
Extended ID : 0x00
Connector : 0x23
Specification : 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Encoding : 0x00
BR Nominal : 0xfa
Length (9um) Km : 0x00
Length (9um) 100m : 0x00
Length (50um) 10m : 0x00
Length (62.5um) 10m : 0x00
Length (copper) 10m : 0x01
Cable Attenuation : 0x00 (2.5 Ghz) 0x00 (5.0 Ghz)
CheckCodeBase : 0xd9 (0xd9)
----------------------------------------
Extended ID Fields
----------------------------------------
Options :
BR Max :
BR Min :
Date Code : 2014-09-29
CheckCodeExt : 0x0e (0x0e)
TX Output Disable : Not Disabled
----------------------------------------
Diagnostics Information
----------------------------------------
Module Monitoring Values:
Current Temp: 19.000 (Celsius)
Supply Volts: 0.000 (Volts)
Channel Monitoring Values:
Recv: 0.000 0.000 0.000 0.000 (dBm)
Bias: 0.000 0.000 0.000 0.000 (mA)
Configuration File Format
The configuration file for the opticstool is:
• Optics ID — The ID of the optics port.
• Name — The printable name of the optics device (you must name the SFPs “SFP” and the QSFPs “QSFP”).
Then four entries describe how to read if a device is present, how to select the MUX for accessing the device, how to reset or
unreset the device, and how to read data from the device.
• Present:
– Bus to use to access presence indicators
– Address of the device that indicates presence
– Register of the device that indicates presence
– Bit(s) in the register that indicates presence (supports single bit and low:high range)
– Value of the bits that indicates presence
– MUX settings to access the device
• Select — Hardware gating.
– Bus to use to access presence indicators
– Address of the device that indicates presence
– Register of the device that indicates presence
– Bit(s) in the register that indicates presence (supports single bit and low:high range)
– Value of the bits that indicates presence
Dell DiagOS Tools 63