Administrator Guide

12 Set the Boot order to the boot from the usb option using the following path:
Boot > Hard Drive BBS Priorities > Boot Option #1
13 In the Boot Option #1 option, select the device that corresponds to your USB device.
14 Select Save and exit the BIOS menu.
Figure 5. Set Boot Option #1 to USB
The BIOS boots from the ONIE Recovery USB.
15 At the Grub menu, select the ONIE: Embed ONIE option, as shown:
lqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
k x ONIE Installer x
tqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqu
x ONIE: Rescue x
x ONIE: Embed ONIE x
x
x
x
x
x
x
x mqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqj
Press [Tab] to edit options
This installs ONIE on the disk and reboots the system to regular ONIE mode. The following shows detailed logs using the
Embed ONIE option on a Dell Networking S6000 platform:
Loading vmlinuz......
Loading initrd.xz.................ready.
Linux version 3.2.35-onie+ (lsharma@netlogin-sjc-03) (gcc version 4.7.3 (crosstool-NG 1.19.0
- ONIE-n.n.n.n) ) #1 SMP Wed Mar 18 20:53:53 PDT 2015
Command line: initrd=initrd.xz console=tty0 console=ttyS0,115200n8 boot_env=recovery
boot_reason=embed install_url=file:///lib/onie/onie-updater BOOT_IMAGE=vmlinuz
.
.
.
.
Please press Enter to activate this console. Info: eth0: Checking link... up.
Info: Trying DHCPv4 on interface: eth0
To check the install status inspect /var/log/onie.log.
Try this: tail -f /var/log/onie.log
** ONIE Update Mode Enabled **
Installation Instructions for ONIE and the Dell OS 15