Administrator Guide

● Assign a WRED profile to either yellow or green traffic.
QOS-POLICY-OUT mode
wred
Displaying Default and Configured WRED Profiles
To display the default and configured WRED profiles, use the following command.
● Display default and configured WRED profiles and their threshold values.
EXEC mode
show qos wred-profile
Example of the show qos wred-profile Command.
DellEMC#show qos wred-profile
Wred-profile-name min-threshold max-threshold max-drop-rate
wred_drop 0 0 100
wred_teng_y 467 4671 100
wred_teng_g 467 4671 50
wred_fortyg_y 467 4671 50
wred_fortyg_g 467 4671 25
Displaying WRED Drop Statistics
To display WRED drop statistics, use the following command.
● Display the number of packets Dell EMC Networking OS the WRED profile drops.
EXEC Privilege mode
show qos statistics wred-profile
DellEMC#show qos statistics wred-profile
Interface Te 1/1
Drop-statistic Dropped Pkts
Green 51623
Yellow 51300
Out of Profile 0
DellEMC#
Displaying egress–queue Statistics
To display the number of transmitted and dropped packets and their rate on the egress queues of an interface, use the following
command:
● Display the number of packets and number of bytes on the egress-queue profile.
EXEC Privilege mode
show qos statistics egress-queue
Pre-Calculating Available QoS CAM Space
Before Dell EMC Networking OS version 7.3.1, there was no way to measure the number of CAM entries a policy-map would
consume (the number of CAM entries that a rule uses is not predictable; from 1 to 16 entries might be used per rule depending
upon its complexity). Therefore, it was possible to apply to an interface a policy-map that requires more entries than are
742
Quality of Service (QoS)