Administrator Guide

Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.1.0 Added support for port-channel interfaces (the port-channel number option).
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Added the backup interface option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command
on the interface. To use the switchport command on an interface, only the no ip address and no
shutdown statements must be listed in the show config output.
When you enter the switchport command, the interface is automatically added to the default VLAN.
To use the switchport backup interface command on a port, first enter the switchport
command. For more information, see “Configuring Redundant Links” in the Layer 2 section in the Dell
EMC Networking OS Configuration Guide.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
Syntax
application {all | application-type}
To remove a management application configuration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
● For DNS, enter the keyword dns.
● For FTP, enter the keyword ftp.
Interfaces 749