Administrator Guide

Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● management route — configure a static route that points to the Management interface or a
forwarding router.
stack-unit portmode quad
Configures the list of dynamic fan-out capable ports.
Syntax
stack-unit [stack-unit number] port port-number portmode quad
To remove the quad-port configuration, use the command.
Parameters
stack-unit
number
Enter the port number. The range is from 1 to 6.
Defaults 49,50,51,52,53,54
Command Modes CONFIGURATION
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.7(0.0) Introduced on the S6000 and S6000–ON.
Usage
Information
For the new quad port profile configuration to take effect, you must first save changes and then reload
the switch.
Interfaces 747