Administrator Guide

Version Description
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced.
Example
DellEMC(conf-if-range-te-2/2,fo-2/56)# show range
2/2 - 0
2/56 - 0
DellEMC(conf-if-range-te-2/2,fo-2/56)#
Related
Commands
● interface — configure a physical interface on the switch.
● show ip interface — display Layer 3 information about the interfaces.
show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the ecmp-group
monitoring enable command. The ECMP group could have a LAG or a list of interfaces (not just LAG link-bundles).
Syntax
show running-config ecmp-group
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Related
Commands
● ecmp-group — configure a mechanism to monitor traffic distribution.
show system stack-unit fanout configured
Displays the details about the fanned-out ports.
Syntax
show system stack-unit stack-unit-number fanout configured
Parameters
stack-unit stack-
unit-number
The stack Unit ID of the device.
fanout
configured
Enter the keywords fanout configured to display the details about the
fanned-out ports.
Defaults None.
Interfaces 743