Administrator Guide

Example
DellEMC(conf)# int tengigabitethernet 1/10
DellEMC(conf-if-te-1/10)# exit
DellEMC(conf)#
Related
Commands
● interface loopback — configure a Loopback interface.
● interface null — configure a Null interface.
● interface port-channel — configure a port channel.
● interface vlan — configure a VLAN.
interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set of configurations on a
group of interfaces.
Syntax
interface group [interface | vlan vlanid {- vlanid } ]
To delete a range of VLANs, use the following command:
no interface group vlan vlanid {- vlanid}
Parameters
interface,
interface,...
Enter the keywords interface group and one of the interfaces — slot/port or
VLAN number. Select the range of interfaces for bulk configuration. Spaces are not
required between the commas. Comma-separated ranges can include VLANs and
physical interfaces.
Enter the member VLANs using VLAN IDs (separated by commas), a range of
VLAN IDs (separated by a hyphen), a single VLAN ID, or a combination. For
example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Slot/Port information need not contain a space before and after the dash. For
example, both of the following commands are valid: interface group
tengigabitethernet 1/1 - 1/5; interface group
tengigabitethernet 1/1-1/5.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL Switch.
Usage
Information
The interface group command will create all the non-existent VLANs specified in the range. On
successful command execution, the CLI switches to the interface group context.
Interfaces 699