Administrator Guide

value Enter the value for the UDF in Hex, up to 24 bytes.
mask Enter the mask for the UDF in Hex, up to 24 bytes.
Defaults None
Command Modes CONFIGURATION-UDF-Qualifier-Value Profile
Example
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
udf-qualifier-value — creates a UDF qualifier value.
udf-tcam — creates a context for UDF TCAM.
show config — displays the current UDF -Qualifier-Value Profile configuration.
udf-qualifier-value
Create a UDF qualifier value to assign values for all UDF IDs.
Syntax
udf-qualifier-value name
To return to the default settings, use the no udf-qualifier-value name command.
Parameters
name Enter the UDF qualifier value profile name, up to 64 characters.
Defaults None
Command Modes CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)# udf-qualifier-value ipnip_val1
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
udf-id — assigns value for each configured UDF ID in the given UDF TCAM profile.
udf-tcam — creates a context for UDF TCAM.
show config — displays the current UDF-Qualifier-Value Profile configuration.
280 Access Control Lists (ACL)