Administrator Guide

O - OSPF
O3 - OSPFv3
R - Static Route (RTM)
M - MPLS
V - VRRP
VT - Vxlan Tunnel
LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
* 1.0.1.1 1.0.1.2 Te 1/49/1 Up 200 200 3 B
* 3.3.3.3 192.168.122.135 Te 1/38 Up 1000 1000 3 VT
* 3.3.3.3 192.168.122.136 Te 1/42 Up 1000 1000 3 VT
* 3.3.3.3 192.168.122.137 Te 1/43 Up 1000 1000 3 VT
* 3.3.3.3 192.168.122.138 Te 1/38 Up 1000 1000 3 VT
* 3.3.3.3 192.168.122.139 Te 1/42 Up 1000 1000 3 VT
Static Virtual Extensible LAN (VXLAN)
When you create a Virtual Extensible LAN (VXLAN) , you need Network Virtualization Platform (NVP) Controller to configure and control
the VXLAN. When you create a VXLAN instance in static mode, you can configure the VXLAN using CLIs instead of using the Controller.
Once you create a VXLAN instance in the static mode, you can create a VNI profile, associate a VNID to the VNI profile, associate a
remote VTEP to the VNID, and associate the VNID to a VLAN using the CLIs.
Configuring Static VXLAN
Port VLAN bindings in the context of VXLAN is achieved by associating a port to VLAN using tagged or untagged interface CLIs. If a
VLAN has VNID associated and the port is VXLAN-enabled, then port-vlan participates in VXLAN and Layer 2 switching does not happen
in that port-vlan. A VXLAN-enabled VLAN can also have non-VXLAN ports as members. But switching cannot happen between VXLAN
ports and non-VXLAN ports.
To configure the static VXLAN on the switch, follow these steps:
1. Enable VXLAN configuration globally on the platform.
CONFIGURATION mode
feature vxlan
2. Enable static VXLAN instance.
CONFIGURATION mode
INTERFACE mode
vxlan-instance instance ID [static]
You can configure vxlan-instance on INTERFACE mode to enable VXLAN on specific ports.
3. Set the local IP Address that can be used as a source for VXLAN tunnels.
VXLAN-INSTANCE mode
local-vtep-ip IP Address
4. Create a VNI profile to associate with remote VTEP configuration.
VXLAN-INSTANCE mode
vni—profile profile name
5. Associate VNID to the VNI profile.
VNI-PROFILE mode
vnid VNID Range
6. Create a remote tunnel and associate the remote VTEP to the VNID.
VXLAN-INSTANCE mode
remote—vtep—ip remote IP Address vni-profile profile name
7. Enable the VXLAN.
VXLAN-INSTANCE mode
no shutdown
8. Enable VXLAN instance on the interface. The interface should not be on layer 2.
INTERFACE mode
vxlan-instance Instance ID
1010
Virtual Extensible LAN (VXLAN)